Hand-reloading requires repetitive grasping of cases and small diameter cases are particularly difficult to hold. The issue is compounded by lubricants requiring more grip force. 

Stop that pain-in-the-brass with the KM Case Holder. Secure a wide range of cases for primer pocket work (head-facing) and, for most rimless cases, case mouth work (neck-facing). This tool accepts hundreds of cartridges thanks to a wide range of collets (Sold Seperatly). The Case Holder design allows for reduced hand tightening to engage the collet. The protrusion* of casing can be set by an internal adjustable backstop (Cases shorter than 1.5” do not contact Backstop).

Collets sold separately. Not compatible with CheyTac and BMG cases.

Store collets in a Collet Block, sold separately here.

Tool Setup

1. Install appropriate collet by removing locking Cap
2. Adjust Backstop with flat head screwdriver to set case protrusion* *Cases shorter than 1.5” do not contact backstop

Instructions for Use

• Install cartridge into collet, twist locking Cap to secure cartridge
• Perform operation(s) as normal (except without hand fatigue)
• Twist Locking Cap to remove the case and repeat

• Please Note - Lightly oil collets for enhanced corrosion protection & periodically lube threads for smooth operation